12/12/2023 0 Comments Do i need xmon for a dcommand![]() ![]() Finally, we tested it with a new XMON unit at the same time, and it runs well, it didn't mute automatically.Īnyone had this problem before? Look forward to receive all of your advise. We have also checked that the XMON cable run properly without hard bending. A series of coincidental collaborations have led Professional Audio Design founder Dave Malekpour and Walters-Storyk Design Group co-principal John Storyk to a. Then, we get back to normal again, the D-Command status shows "XMON ON" and we can hear the audio from the speakers.īut this is only remain for a while, it leads to a situation following a self mute (without pressing mute), where the D-command indicates that it is muted but audio is coming out of the monitors and we cannot change the volume adjustment via the volume knob or either change the speaker input selection (the volume and the speaker input selection are remain to our choice before the self mute occurs), or alternatively (following a mute press but not adjustment) where the D-command indicates it is unmuted but no audio emanates from the monitors. All analog inputs non-chlorine bleach based cleaning solution to a cloth or and outputs on the XMON use DB-25 connectors. But sometimes it does not work, hence we did turn power OFF and ON again on the XMON unit. D-Command connects to the XMON inter- If you need to clean the D-Command top surface, apply a face with a single 15-pin cable (included). Sometimes, you can wiggle the volume knob then release the mute button again to be able to hear the audio again. Talkback 1 Connects as part of the 15-pin Control Cable. But its mono on icon Dcommand and I only have audio on R-speaker. The XMON EUCON Software Application supports both of the Talkback channels (1 and 2) available on XMON. I did, I connected BM out12&13 to Xmon Linein1&2 with DB25XLRF which is connected to Stereo Inputs of Xmon. ![]() for xmms in order to command the running xmms from any script/commandline. Youd just need to wire it up from the BM card to the D-sub connector on the X-mon. ![]() We had this working with Pro Tools HD 12.4 for whatever that is worth. We had an avid tech install a new LED power supply as well as a new fader supply early this year. This happens intermittently, at intervals from a few seconds to a few minutes, regardless of whether Pro Tools is running. Since it uses the WinAmp GUI, it can use WinAmp skins, and play mp3s, mods. Avid / Digidesign D-Command with Xmon Monitor Rack. Then, we tried to release the mute button on the D-Command, but still there is no audio out from the speaker although Pro Tools is running with audio signals on Master Fader. The XMON has been automatically muting its monitor section, it appears on the D-Command status "XMON OFF". We have a customer who recently had a XMON problem. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |